Epson 1400 - Stylus Photo Color Inkjet Printer, Service Manual, Page: 82 / 168

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 82
4.2.1.5 Lower Housing and Printer Mechanism
1. Remove the Upper Housing.
For Stylus Photo 1400/1410: See section 4.2.1.4 on page 80.
For Stylus Photo 1390: See section 4.3.1 on page 128.
2. Grip both ends of the Ink Tube Fastener with your fingers, slide it in the direction
of the arrow, and draw out the Waste Ink Tube from the Ink Tube.
3. Remove the acetate tape that secure the PictBridge Unit Connector Cable to the
Lower Housing. (Skip this procedure for Stylus Photo 1390)
4. Remove the four C.B.P. 3x10 screws and two C.B.S. (P2) 3x10 screws that secure
the Printer Mechanism.
5. Hold the Printer Mechanism by its handling positions with both hands, and remove
it from the Lower Housing.
Figure 4-17. Screws that Secure the Printer Mechanism
C A U T I O N
„ See the page given below to check for sharp metal edges before
starting maintenance/repair.
•
“Sharp Metal Edges” on page 75.
„ Always hold the positions indicated in the figure when handling
the Printer Mechanism to avoid deformation of the frames.
Figure 4-16. Handling of the Printer Mechanism
Handling Positions
1
3
4
Step 2
Ink Tubes
Waste Ink Tubes Fastener
2
1) C.B.P. 3x10
(6±1 kgf.cm)
Printer Mechanism
1) C.B.P. 3x10
(6±1 kgf.cm)
6
Acetate Tape
5
3) C.B.S. (P2) 3x10
(6±1 kgf.cm)
Lower Housing