Epson 1400 - Stylus Photo Color Inkjet Printer, Service Manual, Page: 80 / 168

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 80
4.2.1.4 Upper Housing
1. Remove the Side Housing. See Section 4.2.1.2 on page 78.
2. Open the Printer Cover and Paper Support.
3. Open the Front Cover.
See section 4.2.1.3 on page 79.
4. Remove the four C.B.P. 3x10 screws, three C.B.S. 3x6 screws, and two C.B.P.
3x10 screws that secure the Upper Housing.
Figure 4-12. Screws that Secure the Upper Housing
5. Disconnect the Panel FFC and CD-R Sensor Cable from connectors CN1 and CN2
on the Switch Board, and release the CD-R Sensor Cable from the tabs of the
Upper Housing.
Figure 4-13. Disconnecting the CD-R Sensor Cable and Panel FFC
6. Remove the Guide Pins from the two tabs shown in Figure 4-12 , and remove the
Upper Housing upwards.
C H E C K
P O I N T
See "4.3.1 Upper Housing" on page 128 to remove the Upper
Housing of the Stylus Photo 1390.
Paper
Support
1
Guide Pin
3
Guide Pin
5
4
9
Tab
2
6
Tab
7
8
1) C.B.P. 3x10
(6±1 kgf.cm)
2) C.B.S. 3x6
(6±1 kgf.cm)
15) C.B.P. 3x10
(6±1 kgf.cm)
Upper
Housing
Printer Cover
CD-R Unit
„ Align the Guide Pins with the positioning holes of the Upper
Housing.
See Figure 4-12.
„ When inserting the CD-R Sensor Cable into the Switch Board,
press the connector to make sure that it is firmly installed on
the Switch Board.
„ Referring to Figure 4-13 , correctly route the Panel FFC and
CD-R Sensor Cable.
„ Tighten the screws in the order shown in Figure 4-12.
Tabs
CN2
CN1
Panel FFC
Guide Pin
CD-R Sensor
Cable