Epson 1400 - Stylus Photo Color Inkjet Printer, Service Manual, Page: 72 / 168

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Overview 72
4.1 Overview
This chapter describes procedures for disassembling and assembling EPSON Stylus
Photo 1390/1400/1410. Unless otherwise specified, disassembled units are
reassembled by following the procedures in reverse order.
† WARNING
Procedures that must be followed to avoid injury or loss of life.
† CAUTION
Procedures that must be followed to avoid damaging the printer or test equipment.
† CHECK POINT
Emphasize a particularly important process or procedure.
† REASSEMBLY
Indicated when the assembling procedure differs to simple reverse-assembly.
† ADJUSTMENT REQUIRED
Indicated if adjustments need to be carried out to complete the repair.
Refer to the exploded diagrams in the Appendix, when disassembling of any unit or
parts that are not described in this chapter.
Always read the precautions described in the next section before starting maintenance/
repair.
4.1.1 Precautions
Prior to disassembling/reassembling this product, always read the following
“WARNING” and “CAUTION” carefully.
W A R N I N G
„ Always disconnect the power cable. Working with the power
cable plugged in for cases such as voltage measurement, be
extremely careful not to get an electric shock, and strictly
follow the procedures in this manual.
„ Wear protective goggles to protect your eyes from ink. If ink
gets in your eyes, wash with clean water and see a doctor.
„ To prevent injury from sharp metal edges, always wear gloves
for disassembly and reassembly.
„ If ink gets on your skin, wash with soap and water. If skin
irritation occur, see a doctor.
„ To protect the microprocessors and circuitry, use static
discharge equipment, such as anti-static wrist straps when
accessing the internal components.
C A U T I O N
„ When transporting this printer, remove all cartridges. Remove
Cartridges especially for air transportation, due to reduction of
atmospheric pressure likely to cause ink leakage.
„
Use only the recommended tools for disassembly, reassembly
and adjustment.
Refer to
Table 4-1 “List of Tools” .
„ Tighten screws to the specified torques.
„ Carry out required adjustments.
Refer to
“ADJUSTMENT” on page 131.
„ Use the specified lubricants and adhesives.
Refer to
“MAINTENANCE” on page 148.
„ When using compressed air products; such as air duster, for
cleaning during repair and maintenance, the use of such
products containing flammable gas is prohibited.