Epson 1400 - Stylus Photo Color Inkjet Printer, Service Manual, Page: 103 / 168

EPSON Stylus Photo 1390/1400/1410 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly/Assembly Procedures 103
18. To prevent the CR Scale Cover from interfering with the back of the Carriage
Unit, slide the Carriage unit to the left side, shift the Carriage Shaft to the left
direction to remove the Carriage Shaft from both the Main Frame and the Carriage
Unit, release the right end from the Main Frame, and draw out the Carriage shaft.
Figure 4-76. Removing the Carriage Shaft
19. Remove the CR Drive Belt from the Carriage Unit.
Figure 4-78. Removing the CR Drive Belt
C A U T I O N
When performing the following procedure, take care not to scratch
the Carriage Shaft.
Interference
point
1
2
3
Carriage
Unit
Carriage Shaft
CR Scale Cover
„ Set the longer end of the Carriage Shaft to the left side.
„ When the Carriage Shaft is removed, the Plain Spring and Leaf
Spring that are attached to the right end of the Carriage Shaft
may drop off. In such case, be sure to attach them in the order
as shown in the figure below
Figure 4-77. Installing the Carriage Shaft
Refer to the figure below and install the CR Drive Belt so that its
top and rear sides face the correct way.
Figure 4-79. Installing the CR Drive Belt
Leaf Spring
Plain Spring Carriage Shaft
Left Side Right
Side
Longer
Shorter
Carriage Unit
CR Drive Belt
With Tooth Surface
Without Tooth Surface
Both Surfaces have Tooth