Emerson Rosemount 5900S Series, Reference Manual

Page: 141 / 298

L_TYPE is
indirect When an inferred measurement is made based on the sensor
measurement, set the XD_SCALE to represent the operating range that
the sensor will see in the process. Determine the inferred measurement
values that correspond to the XD_SCALE 0 and 100% points and set these
for the OUT_SCALE.
L_TYPE is
indirect
square root When an inferred measurement is made based on the transmitter
measurement and the relationship between the inferred measurement
and sensor measurement is square root, set the XD_SCALE to represent
the operating range that the sensor will see in the process. Determine the
inferred measurement values that correspond to the XD_SCALE 0 and
100% points and set these for the OUT_SCALE.
Engineering units
Note
To avoid configuration errors, only select engineering units for XD_SCALE and OUT_SCALE
that are supported by the device.
Related information
Supported units
4.11.2 Factory supplied AI blocks
The Rosemount 5900S is supplied with six pre-configured AI blocks according to Table 4-6 .
The block configuration can be changed if needed.
Table 4-6: Factory Supplied AI Blocks for the Rosemount 5900S
AI Block Channel L-Type Units
1 CHANNEL_LEVEL Direct Meter
2 CHANNEL_DISTANCE Direct Meter
3 CHANNEL_LEVELRATE Direct Meter per hour
4 CHANNEL_SIGNAL_STRENGTH Direct mV
5 CHANNEL_HOUSING_TEMPERATURE Direct deg C
6 CHANNEL_VOLUME Direct m
3
4.11.3 Modes
The AI Function Block supports three modes of operation as defined by the MODE_BLK
parameter:
Manual (Man) The block output (OUT) may be set manually.
Automatic
(Auto) OUT reflects the analog input measurement or the simulated value
when simulation is enabled.
Out of Service
(O/S) The block is not processed. FIELD_VAL and PV are not updated and
the OUT status is set to Bad: Out of Service. The BLOCK_ERR
parameter shows Out of Service. In this mode, you can make
Reference Manual Configuration
00809-0100-5900 September 2019
Rosemount 5900S Radar Level Gauge 141