Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 28 / 394

2-8 Setting Up and Using Laser Alignment Fixtures
* If a minor error is present, the data being acquired may be marginal. The data
quality will depend on the error. If a major error is present, then some kind of hard-
ware or system problem exists. Therefore, the data being acquired is rejected.
X (flashing)
Low battery 1st warning (sensor
head) - The Laser Head has the
ability to monitor its own
battery power. The battery
power is checked periodically
to determine if it is below the
minimum acceptable power.
When the battery power
reaches 4.8 volts, the LED will
be flashed off for 0.5 sec. and
then flashed on for 0.5 sec. Data
is accepted when the battery is
this state. Recharge sensor heads.
X
Major Error* Refer to “(6) Laser Head Status
Screen” on page 3-16 for more
information on the error and the
required action.
X (flashing)
Low battery 2nd/final warning
(sensor head) - The Laser Head
has the ability to monitor its
own battery power. The battery
power is checked periodically
to determine if it is below the
minimum acceptable power.
When the battery power
reaches 4.2 volts, the LED will
be flashed off for 0.5 sec. and
then flashed on for 0.5 sec. Data
is not accepted when the battery
is this state. Recharge sensor heads.
Table 1:
LED Status Meaning Required Action
Green Yellow Red