Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 86 / 394

3-6 Horizontal Alignment
Main Screen Function Keys
Enter Dimensions
Use the Enter Dimensions key to advance to the Edit Dimensions screen where the
dimensions for the machine being aligned can be entered. This is the first step of
the three-key operation used in performing an alignment job. If thermal growth is
enabled, thermal growth information can also be entered from under this step.
Refer to the Enter Dimensions section on page 3-45 for more information.
Sweep Laser Heads
Use the Sweep Laser Heads key to advance to the data acquisition screen for the
alignment method defined for the job. This is the second step of the three-key
operation used in performing an alignment job. From this screen alignment data
needed to determine the alignment condition of the machine is acquired. If foot
pre-check is enabled, a Soft Foot or FDI check can also be performed from under
this step. Refer to the Sweep Laser Heads section on page 3-75 for more informa-
tion.
Move Machine
Use the Move Machine key to advance to the Vertical Move screen where the
machine moves and alignment condition for the vertical direction can be reviewed.
This is the third step of the three-key operation used in performing an alignment
job. After the Vertical Move screen, the program advances to the Horizontal Move
screen where the machine moves and alignment condition for the horizontal
direction can be reviewed. If an alignment correction is necessary that requires a
live move, this can also be done from under this step. Refer to the Move Machine
section on page 3-129 for more information.
Note
The Enter key will perform the same function as the soft key for the
highlighted program step. In addition, the Enter key can be used to
advance you through an alignment job from beginning-to-end using
the job parameters and flow setup on the Alt Main screen.