Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 32 / 394

2-12 Setting Up and Using Laser Alignment Fixtures
The current version of the 8211 charger will charge both the former and current
versions of the 8215/8225 laser heads but at a slower charge rate than the older ver-
sion of the 8211 charger. The former version of the 8211 charger charges the
former version of the 8215/8225 laser heads, but it will only trickle charge the cur-
rent version of the 8215/8225 laser heads. Although no damage will occur if the
Fast Charge cycle is initiated, this cycle will not work for the current version of the
laser heads.
To set up the 8211 charger, complete these steps:
1. . . plug the power cord into the power supply,
2. . . plug the power cord into an AC receptacle,
3. . . plug the power supply into the 8211 charger in the top end cap.
At that time, the beeper will sound indicating that power has been applied to the
battery charger. As a test, all LEDs will illuminate for 1.5 seconds.
4. . . Plug the analyzer charging cable into the bottom end cap.
The sensor heads and analyzer can now be charged either individually or, all at the
same time.
Charging the Sensor Heads with the Model 8211 Charger
Drop them over the posts so that the head faces outward as shown in the previous
illustration. Heads can be charged individually or together.
Indicator Light Charging Status
Pending Waiting for safe voltage and
temperature
Discharge (steady) Batteries discharging
Discharge (flashing) Discharge requested, waiting
for safe voltage or temperature
Fast (steady) Batteries in fast charge
Fast (flashing) Fast charge requested, waiting
for safe voltage or temperature
Trickle Batteries in trickle charge,
topping-off, or charge complete