Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 21 / 394

Chapter
2-1
2
Setting Up and Using Laser Alignment Fixtures
Special Instructions About the 8215/8225 Laser Fixtures
Warning!
Prior to mounting the laser alignment fixtures on machine shafts, all
switches operating the machines should be “locked out” (follow
lockout procedures for your facility). On completion of the align-
ment, inspect the work area to ensure that all equipment is clear of
rotating shafts and couplings, prior to removal of the lockout protec-
tion.
Warning!
The 8215/8225 Laser Alignment Fixtures use a Class II (CDRH) laser
or Class 2 (IEC) laser. This laser complies with 21 CFR 1040.10 and
1040.11 safety requirements with a power output < 1.0 mW (average)
and a pulse repetition of 600 pulses/sec. The pulse duration is <110
microseconds. However, do not expose the human eye directly to the
laser beam! Warnings are located on each sensor head.
Warning!
Using the controls or adjustments in ways other than specified in this
documentation may result in hazardous laser radiation exposure.
Making the hardware, firmware, or software perform in ways other
than specified in this documentation may result in hazardous laser
radiation exposure.