Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 15 / 394

1-3 How To Use This Manual
Introduction
The UltraSpec Pro 8215/8225 Laser Alignment Fixtures are the latest in a com-
plete line of alignment equipment provided by Emerson Process Management.
The 8215/8225 system is used in conjunction with the Model 2130 Laser Align pro-
gram. Although the Model 2130 analyzer can be purchased separately, it must be
used to process the data from the fixtures. The Model 8215/8225 system attaches
sensor heads to shafts which are typically coupled. Laser beams are emitted from
each sensor head and targeted on the opposite sensor head. Each shaft position is
measured in relation to the other shaft by rotating the two shafts. Shaft misalign-
ment is calculated from the position of each laser beam on its respective target, at a
range of angular positions of the laser heads.
The position of each laser beam on its target transmits from each sensor head to
the Model 2130 analyzer through radio frequency (RF) or direct cable communi-
cation, depending on the model. The Model 2130 analyzer processes the data and
calculates the required machine moves necessary to bring the machine compo-
nents into alignment.
With most alignment systems available today, the sag of the alignment fixtures must
be considered to accurately calculate machine moves. With the use of laser beams,
there is no fixture sag to consider! The RF communication between the sensor
heads and the Model 2130 analyzer simplifies data acquisition and reduces oper-
ator error. The direct cable connect provides an alternate method to transfer data
when the RF link is not practical.
Since each head has a self-contained inclinometer and additional memory, the
data can be acquired through a variety of methods. Choices range from the tradi-
tional top, bottom, left, and right locations (minimum of three) - where the fixtures
interact directly with the analyzer to the patented partial sweep method (the sensor
heads memorize the data and later dump it to the analyzer).
When the 8215/8225 fixtures and the 2130 Laser Align program are used with the
UltraMgr PC software program, a complete alignment program can be managed
from a centralized location. UltraMgr provides job tracking, control of alignment
tolerances, alignment history and much more.