Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 224 / 394

3-144 Horizontal Alignment
Up, Down, Left, and Right Arrow keys
Use the Up, Down, Left, and Right Arrow keys to select the field you want to modify
(highlighted with the red box around it).
Refer to the following table for a description of each dimension.
When a value has been entered in the Dimensions section of the display, then the
vertical (V1-V4) and horizontal (H1-H4) move for those extra feet are calculated
and displayed to the right.
The amount of movement will be expressed in either mils or millimeters (mm),
depending on the analyzer units.
V1-V4
If the movement is upward it displays as a positive number. If the movement is
downward it displays as a negative.
H1-H4
If the movement is to the left (viewed from the outboard end of the right machine
looking towards the left machine) it displays as a positive number. If the movement
is to the right (viewed from the outboard end of the right machine looking towards
the left machine) it displays as a negative number.
Dimension Measurement Description
Measure
to the
Nearest
A1-A4
Center of outboard foot of the machine on the left to the center of
the extra foot. If the extra foot is located to the right of the
outboard foot on the left machine, enter a positive (+) value. If
the extra foot is located to the left of the outboard foot on the left
machine, enter a negative (–) value.
1/8 inch
(3 mm)
E1-E4
Center of inboard foot of the machine on the right to the center of
the extra foot. If the extra foot is located to the right of the
inboard foot on the right machine, enter a positive (+) value. If
the extra foot is located to the left of the inboard foot on the right
machine, enter a negative (–) value.
1/8 inch
(3 mm)