Emerson 2130 RBM Consultant Pro, Reference Manual

Page: 255 / 394

3-175 Laser Address Selection
Display Actual Data key
Use the Display Actual Data key, to see the “raw data,” (the position of the beam on
each target). If the top reading for both machines is zero (such as the case would
be if the saved reading set was the averaged result from multiple acquisitions) this
key is not available.
Enter key
Use the Enter key, to return to the tolerance plot screens.
C-face Alignment
After alignment data is acquired, the C-face option can be used to display align-
ment data for machines in which the machine moves are done on a machine with
a circular flange with a basic four bolt pattern. If the setup for a rectangular or
custom flange pattern is required you will need to change the job to a Vertical align-
ment job. Refer to the Vertical Alignment section on page 4-1 for more informa-
tion.