Docomo L-06A Prime Series, Instruction Manual

Page: 532 / 553

f
Enter an access point (APN) in the
following format ▶ Press
AT+CGDCONT=<cid>,"<PDP type>","<APN>" .
Enter the following information in the
corresponding <cid>, <PDP type>, and <APN>
sections.
If "OK" appears after you enter the information,
the access point (APN) has been setup.
cid : Enter any number from 2, and from
4 to 11.
* Note that the old setting
information will be overwritten if
you select a cid number which has
already been set.
PDP type : Select either PPP or IP for the
connection method supported by
the access point, and then enter the
information enclosed with quotation
marks " ".
APN : Enter the access point (APN)
enclosed with quotation marks " ".
• If the entered characters do not appear, enter
ATE1 .
To register an access point with PPP as the
PDP type and XXX.com as the APN to cid2
b
To reset the access point (APN) settings
of the specified cid
Enter AT+CGDCONT=<cid> .
b
To view the registered access point
(APN)
Enter AT+CGDCONT? .
g
Click "ファイル (File)" ▶ "ハイパーター
ミナルの終了 (Exit Hyper Terminal)"
h
Click [はい (Yes)] on the
confirmation to disconnect screen
▶ Click [いいえ (No)] on the
confirmation to save screen
Hyper Terminal will quit, and the setting of the
access point (APN) completes.
Note
• The access point (APN) information is saved
on the FOMA terminal. If you connect a different
FOMA terminal, register the access point (APN)
information again.
• If you want to use the access point (APN)
information saved on the PC, register the same
access point (APN) to the same cid on the FOMA
terminal.
Setting to Show/Hide Caller ID
You can set whether to show your caller ID to
the access point during packet communication.
This section describes how to use an AT
command (*DGPIR command→P24) to
configure the settings prior to connecting.
Your caller ID is valuable information. Be
sufficiently cautious when showing your caller
ID.
• "Hyper Terminal" does not run on Windows Vista.
To configure the settings in Windows Vista, use
communication software compatible with Windows
Vista. For the setting procedure, refer to the
instruction manual and other documentation that
come with the software to be used.
a
Perform Steps 1 to 5 in "Setting
Access Point (APN)" (P14)
Hyper Terminal starts.
b
Use an AT command to set whether
to show (186) or hide (184) caller
ID
Enter the AT command in the AT*DGPIR=<n>
format as follows.
If "OK" appears after you enter the AT command,
the setting of whether to show or hide caller ID is
completed.
• If the entered characters do not appear, enter
ATE1 .
b
To hide caller ID
AT*DGPIR=1
When you make or answer a call, 184 is
added automatically.
b
To show caller ID
AT*DGPIR=2
When you make or answer a call, 186 is
added automatically.
b
To reset the show/hide caller ID setting
to its default (unset) using a *DGPIR
command
AT*DGPIR=0
Note
• When you use the DOCOMO Internet connection
service "mopera U" or "mopera", the caller ID
needs to be set to "通知 (Show)"
Continue on the next page