Docomo L-06A Prime Series, Instruction Manual

Page: 201 / 553

i-mode/i-motion/i-Channel
Others
Configuring Other Settings
a
i-mode menu screen (P182) ▶ "i-mode setting"
▶ "Others" ▶ Perform the following operations
[Check settings]
Check the options set in "i-mode setting".
[Reset settings]
Reset the options set in "i-mode setting" to the default.
▶ Enter the Terminal security code ▶ "Yes"
Connection timeout
Setting Connection Timeout
Set the timeout duration until the connection is automatically
terminated if there is no response due to network traffic.
a
i-mode menu screen (P182) ▶ "i-mode setting"
▶ "Communication" ▶ "Connection timeout" ▶
"60 seconds"/"90 seconds"/"Unlimited"
• If set to "Unlimited", the connection will not be automatically
terminated.
Note
• Even if set to "Unlimited", the connection attempt may be
terminated depending on the signal strength etc.
Host selection
Changing Access Point from i-mode
* If you use the DOCOMO i-mode service, changing the
access point is not required.
Set an Access Point Name (APN) used when you use services
other than i-mode (DOCOMO). i-mode and i-mode mail become
unavailable when you connect to an APN other than DOCOMO.
Adding Access Points
a
M
▶ "Settings" ▶ "International roaming" ▶
"Network" ▶ "Host selection"
Host selection
screen
b I
[Add] ▶ Enter the Terminal security code ▶
Perform the following operations
[Host name]
Enter the access point name within 15 full-pitch or 30 half-pitch characters.
[Host number]
Enter the number of the access point within 99 half-pitch alphanumeric
characters.
[Host address]
Enter the access point address within 30 half-pitch alphanumeric characters.
Continued on next page