Docomo L-06A Prime Series, Instruction Manual

Page: 331 / 553

Data Management
Receiving a Piece of Data
a
M
▶ "LifeKit" ▶ "Receive Ir data" ▶ "Receive"
▶ "Yes"
b
Perform infrared transmission operations on
the sending device
Infrared communication starts.
c
"Yes"
Send/Receive all via infrared communication
Sending and Receiving All Data
You can exchange all data with a PC or another FOMA
terminal at a time.
• To exchange all data, an authentication password is used to
identify the FOMA terminals of both sender and receiver correctly.
An authentication password is any 4-digit number that you selected
before infrared communication and should be entered both on the
sending and receiving devices.
Sending All Data
• Set the receiving device to the infrared receiving mode before
sending data.
Example: To send all Phonebook entries on the FOMA terminal
a
Stand-by display ▶
D
▶
M
[Menu] ▶ "Send Ir
data" ▶ "all in phone"
• If an image is set to a Phonebook entry, a warning indicating
that it may take a while to send appears. Select "Yes" to send.
b
Enter the Terminal security code ▶ Enter the
authentication password ▶ "Yes"
Infrared communication starts.
Note
• A message appears if the destination device cannot be found.
Check the distance and angle with the other party again.
• Files in "My picture" cannot be sent at a time (one file can be
sent at a time).
Receiving All Data
• Receiving all data overwrites over the data on the FOMA terminal
and deletes all saved data including protected mails. Make sure that
important data is not saved before sending or receiving all data.
a
M
▶ "LifeKit" ▶ "Receive Ir data" ▶
"Receive all" ▶ "Yes"
b
Enter the Terminal security code ▶ Enter the
authentication password
c
Perform infrared transmission operations on
the sending device
Infrared communication starts.
d
"Yes"