Docomo L-06A Prime Series, Instruction Manual

Page: 388 / 553

Character Entry
Note
• You can also copy/cut and paste characters by performing the
following operation;
M
[Menu] (for 1+ seconds) ▶ Use
K
to move the cursor to
start point ▶
C
[Select] ▶ Use
K
to move the cursor to end
point ▶
C
[Select] ▶ "Copy"/"Cut" ▶ Open the character entry
destination screen ▶ Use
K
to move the cursor to pasting
position ▶
A
• Pressing
A
(for 1+ seconds) also undo a cut or paste
operation.
• If copied or cut text contains more characters than the
allowable number of characters, the excess characters are
truncated when pasted.
• Characters can be pasted only if copied or cut text can be
entered in the destination screen. For example, Hiragana or
Kanji characters cannot be pasted in the mail address field
(half-pitch alphanumeric characters).
• Line feeds in a copied text are replaced with half-pitch spaces
if the text is pasted to an input screen that does not allow line
feeds.
• When pasting in the Deco-mail message after copying or
cutting, the decoration information will also be pasted (except
for some decoration information).
Kuten code
Entering Characters Using
Kuten Code
You can enter a 4-digit Kuten code to enter a letter, numeric
character, or symbol, etc.
• For the Kuten code list table, refer to "Kuten Code List" on the
bundled CD-ROM in PDF format.
a
Character entry screen (P376) ▶
M
[Menu] ▶
"Special input" ▶ "Kuten code"
Kuten Code entry
screen
b
Enter the Kuten code (4-digit number) for the
character ▶
C
[Select]
The associated character is entered.
• If you proceed to press
C
[Select], the selected characters
will be entered in serial.