Digisol DG-FS4526E, Management Manual

Page: 882 / 1162

C
HAPTER
34 | ERPS Commands
– 882 –
Alternatively, the closest neighbor to the east should be the next node in
the ring in a clockwise direction, and the closest neighbor to the west
should be the next node in the ring in a counter-clockwise direction.
E
XAMPLE
Console(config-erps)#ring-port east interface ethernet 1/12
Console(config-erps)#
rpl owner
This command configures a ring node to be the Ring Protection Link (RPL)
owner or a non-owner.
S
YNTAX
[ no ] rpl owner
D
EFAULT
S
ETTING
non-owner
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
Only one RPL owner can be configured on a ring. The owner blocks
traffic on the RPL during Idle state, and unblocks it during Protection
state (that is, when a signal fault is detected on the ring).
The east and west connections to the ring must be specified for all ring
nodes using the ring-port command. When this switch is configured as
the RPL owner, the west ring port is set as being connected to the RPL.
E
XAMPLE
Console(config-erps)#rpl owner
Console(config-erps)#
wtr-timer
This command sets the wait-to-restore timer which is used to verify that
the ring has stabilized before blocking the RPL after recovery from a signal
failure. Use the no form to restore the default setting.
S
YNTAX
wtr-timer minutes
minutes - The wait-to-restore timer is used to verify that the ring
has stabilized before blocking the RPL after recovery from a signal
failure. (Range: 5-12 minutes)
D
EFAULT
S
ETTING
5 minutes