Digisol DG-FS4526E, Management Manual

Page: 410 / 1162

C
HAPTER
15 | Basic Administration Protocols
Simple Network Management Protocol
– 410 –
SNMP Version 3
IP Address – IP address of a new management station to receive
notification message (i.e., the targeted recipient).
Version – Specifies whether to send notifications as SNMP v1, v2c, or
v3 traps.
Notification Type
Traps – Notifications are sent as trap messages.
Inform – Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps
are used)
Timeout – The number of seconds to wait for an
acknowledgment before resending an inform message.
(Range: 0-2147483647 centiseconds; Default: 1500
centiseconds)
Retry times – The maximum number of times to resend an
inform message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
Local User Name – The name of a local user which is used to identify
the source of SNMPv3 trap messages sent from the local switch.
(Range: 1-32 characters)
If an account for the specified user has not been created ( page 403 ),
one will be automatically generated.
Remote User Name – The name of a remote user which is used to
identify the source of SNMPv3 inform messages sent from the local
switch. (Range: 1-32 characters)
If an account for the specified user has not been created ( page 405 ),
one will be automatically generated.
UDP Port – Specifies the UDP port number used by the trap manager.
(Default: 162)
Security Level – When trap version 3 is selected, you must specify
one of the following security levels. (Default: noAuthNoPriv)
noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted.
AuthPriv – SNMP communications use both authentication and
encryption.