Digisol DG-FS4526E, Management Manual

Page: 565 / 1162

C
HAPTER
20 | General Commands
– 565 –
C
OMMAND
U
SAGE
This command resets the entire system.
Any combination of reload options may be specified. If the same option
is re-specified, the previous setting will be overwritten.
When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config command (See
"copy" on page 591 ).
E
XAMPLE
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable
This command activates Privileged Exec mode. In privileged mode,
additional commands are available, and certain commands display
additional information. See "Understanding Command Modes" on
page 556 .
S
YNTAX
enable [ level ]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
D
EFAULT
S
ETTING
Level 15
C
OMMAND
M
ODE
Normal Exec
C
OMMAND
U
SAGE
“super” is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
enable password command.)
The “#” character is appended to the end of the prompt to indicate that
the system is in privileged access mode.