Digisol DG-FS4526E, Management Manual

Page: 862 / 1162

C
HAPTER
33 | Spanning Tree Commands
– 862 –
Path cost takes precedence over port priority.
When the path cost method ( page 853 ) is set to short, the maximum
value for path cost is 65,535.
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree cost 50
Console(config-if)#
spanning-tree edge-
port
This command specifies an interface as an edge port. Use the no form to
restore the default.
S
YNTAX
spanning-tree edge-port [ auto ]
no spanning-tree edge-port
auto - Automatically determines if an interface is an edge port.
D
EFAULT
S
ETTING
Auto
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
You can enable this option if an interface is attached to a LAN segment that
is at the end of a bridged LAN or to an end node. Since end nodes cannot
cause forwarding loops, they can pass directly through to the spanning tree
forwarding state. Specifying Edge Ports provides quicker convergence for
devices such as workstations or servers, retains the current forwarding
database to reduce the amount of frame flooding required to rebuild
address tables during reconfiguration events, does not cause the spanning
tree to initiate reconfiguration when the interface changes state, and also
overcomes other STA-related time out problems. However, remember that
Edge Port should only be enabled for ports connected to an end-node
device.
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#