Digisol DG-FS4526E, Management Manual

Page: 797 / 1162

C
HAPTER
27 | Interface Commands
– 797 –
show interfaces
transceiver
This command displays identifying information for the specified transceiver,
as well as the temperature, voltage, bias current, transmit power, and
receive power.
S
YNTAX
show interfaces transceiver [ interface ]
interface
ethernet unit / port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: SFP ports 9-10)
D
EFAULT
S
ETTING
Shows all SFP interfaces.
C
OMMAND
M
ODE
Privileged Exec
Unknown-unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if
enabled it also shows the threshold level ( page 791 ).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
( page 806 ).
Ingress/Egress
Rate Limit
Shows if rate limiting is enabled, and the current rate limit ( page 825 ).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid ( page 898 ).
Ingress Rule Shows if ingress filtering is enabled or disabled ( page 897 ).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
( page 896 ).
Native VLAN Indicates the default Port VLAN ID ( page 899 ).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames ( page 932 ).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled
( page 890 ).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates
untagged and “(t)” indicates tagged ( page 896 ).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP
( page 890 ).
802.1Q-tunnel
Status
Shows if 802.1Q tunnel is enabled on this interface ( page 903 ).
802.1Q-tunnel
Mode
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Uplink ( page 904 ).
802.1Q-tunnel
TPID
Shows the Tag Protocol Identifier used for learning and switching packets
( page 906 ).
Table 95: show interfaces switchport - display description (Continued)
Field Description