Digisol DG-FS4526E, Management Manual

Page: 161 / 1162

C
HAPTER
5 | Interface Configuration
Traffic Segmentation
– 161 –
P
ARAMETERS
These parameters are displayed:
Status – Enables port-based traffic segmentation. (Default: Disabled)
Uplink-to-Uplink Mode – Specifies whether or not traffic can be
forwarded between uplink ports assigned to different client sessions.
Blocking – Blocks traffic between uplink ports assigned to different
sessions.
Forwarding – Forwards traffic between uplink ports assigned to
different sessions.
W
EB
I
NTERFACE
To enable traffic segmentation:
1.
Click Interface, Traffic Segmentation.
2. Select Configure Global from the Step list.
3.
Mark the Status check box, and set the required uplink-to-uplink mode.
4. Click Apply.
Figure 53: Enabling Traffic Segmentation
C
ONFIGURING
U
PLINK
AND
D
OWNLINK
P
ORTS
Use the Interface > Traffic Segmentation (Configure Session) page to
assign the downlink and uplink ports to use in the segmented group. Ports
designated as downlink ports can not communicate with any other ports on
the switch except for the uplink ports. Uplink ports can communicate with
any other ports on the switch and with any designated downlink ports.
CLI R
EFERENCES
"Configuring Port-based Traffic Segmentation" on page 912