Digisol DG-FS4526E, Management Manual

Page: 145 / 1162

C
HAPTER
5 | Interface Configuration
Port Configuration
– 145 –
Short: Shorted pair
Not Supported: This message is displayed for any Fast Ethernet
ports that are linked up, or for any Gigabit Ethernet ports linked up
at a speed lower than 1000 Mbps.
Impedance mismatch: Terminating impedance is not in the
reference range.
Ports are linked down while running cable diagnostics.
P
ARAMETERS
These parameters are displayed:
Port – Switch port identifier.
Type – Displays media type. (FE – Fast Ethernet, GE – Gigabit
Ethernet)
Link Status – Shows if the port link is up or down.
Test Result – The results include common cable failures, as well as the
status and approximate distance to a fault, or the approximate cable
length if no fault is found.
Last Updated – Shows the last time this port was tested.
W
EB
I
NTERFACE
To test the cable attached to a port:
1. Click Interface, Port, Cable Test.
2. Click Test for any port to start the cable test.
Figure 36: Performing Cable Tests