Digisol DG-FS4526E, Management Manual

Page: 343 / 1162

C
HAPTER
14 | Security Measures
Configuring Port Security
– 343 –
C
OMMAND
U
SAGE
A secure port has the following restrictions:
It cannot be used as a member of a static or dynamic trunk.
It should not be connected to a network interconnection device.
The default maximum number of MAC addresses allowed on a secure
port is zero. You must configure a maximum address count from
1 - 1024 for the port to allow access.
If a port is disabled (shut down) due to a security violation, it must be
manually re-enabled from the Interface > Port > General page
( page 129 ).
P
ARAMETERS
These parameters are displayed:
Port – Port number.
Action – Indicates the action to be taken when a port security violation
is detected:
None : No action should be taken. (This is the default.)
Trap : Send an SNMP trap message.
Shutdown : Disable the port.
Trap and Shutdown : Send an SNMP trap message and disable the
port.
Security Status – Enables or disables port security on the port.
(Default: Disabled)
Max MAC Count – The maximum number of MAC addresses that can
be learned on a port. (Range: 0 - 1024, where 0 means disabled)
The maximum address count is effective when port security is enabled
or disabled, but can only be set when Security Status is disabled.