Digisol DG-FS4526E, Management Manual

Page: 667 / 1162

C
HAPTER
24 | Authentication Commands
RADIUS Client
– 667 –
radius-server auth-
port
This command sets the RADIUS server network port. Use the no form to
restore the default.
S
YNTAX
radius-server auth-port port-number
no radius-server auth-port
port-number - RADIUS server UDP port used for authentication
messages. (Range: 1-65535)
D
EFAULT
S
ETTING
1812
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#radius-server auth-port 181
Console(config)#
radius-server host
This command specifies primary and backup RADIUS servers, and
authentication and accounting parameters that apply to each server. Use
the no form to remove a specified server, or to restore the default values.
S
YNTAX
[ no ] radius-server index host host-ip-address [ acct-port acct-port ]
[ auth-port auth-port ] [ key key ] [ retransmit retransmit ]
[ timeout timeout ]
index - Allows you to specify up to five servers. These servers are
queried in sequence until a server responds or the retransmit period
expires.
host-ip-address - IP address of server.
acct-port - RADIUS server UDP port used for accounting messages.
(Range: 1-65535)
auth-port - RADIUS server UDP port used for authentication
messages. (Range: 1-65535)
key - Encryption key used to authenticate logon access for client.
Do not use blank spaces in the string. (Maximum length: 48
characters)
retransmit - Number of times the switch will try to authenticate
logon access via the RADIUS server. (Range: 1-30)
timeout - Number of seconds the switch waits for a reply before
resending a request. (Range: 1-65535)