Digi AnywhereUSB Plus, User Manual, Page: 664 / 815

Virtual Private Networks (VPN) NEMO
AnywhereUSB® Plus User Guide 664
a. Add a local network to use as a virtual NEMO network interface:
(config vpn nemo nemo_example)> add network end eth2
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Show NEMO status
É
WebUI
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access.
2. On the menu, select Status > NEMO .
The NEMO page appears.
3. To view configuration details about an NEMO tunnel, click the ­ (configuration) icon in the
upper right of the tunnel's status pane.
Command line
1. Log into the AnywhereUSB Plus command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. To display details about all configured NEMO tunnels, type the following at the prompt:
> show nemo
NEMO Enable Status Address Agent CoAddress
---- ------ ------ ------- ------- ----------
demo false
test true up 1.2.3.4 4.3.2.1 10.10.10.1
>
3. To display details about a specific tunnel:
> show nemo name test
test NEMO Status
----------------
Enabled
: true