Digi AnywhereUSB Plus, User Manual, Page: 247 / 815

Services Simple Network Management Protocol (SNMP)
AnywhereUSB® Plus User Guide 247
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the SNMP agent:
(config)> service snmp enable true
(config)>
4. Configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service snmp acl address end value
(config)>
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any : No limit to IPv4 addresses that can access the SNMP service.
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service snmp acl address6 end value
(config)>
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any : No limit to IPv6 addresses that can access the SNMP service.
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the AnywhereUSB
Plus device:
(config)> add service snmp acl interface end value
(config)>
Where value is an interface defined on your device.