Digi AnywhereUSB Plus, User Manual, Page: 153 / 815

Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide 153
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Note If the SIM remains in a locked state after using the unlock command, contact your cellular
carrier.
Signal strength for cellular connections
See Show cellular status and statistics for procedures to view this information.
Signal strength for 4G connections
For 4G connections, the RSRP value determines signal strength.
n
Excellent : > -90 dBm
n
Good : -90 dBm to -105 dBm
n
Fair : -106 dBm to -115 dBm
n
Poor : -116 dBm to -120 dBm
n No service : < -120 dBm
Signal strength for 3G and 2G connections
For 3G and 2G cellular connections, the current RSSI value determines signal strength.
n
Excellent : > -70 dBm
n
Good : -70 dBm to -85 dBm
n Fair : -86 dBm to -100 dBm
n
Poor : < -100 dBm to -109 dBm
n
No service : -110 dBm
Tips for improving cellular signal strength
If the signal strength LEDs or the signal quality for your device indicate Poor or No service , try the
following things to improve signal strength:
n
Move the AnywhereUSB Plus device to another location.
n
Try connecting a different set of antennas, if available.
n Purchase a Digi Antenna Extender Kit:
l
Antenna Extender Kit, 1m
l
Antenna Extender Kit, 3m
AT command access
To run AT commands from the AnywhereUSB Plus command line:
Command line