Digi AnywhereUSB Plus, User Manual, Page: 301 / 815

Services Use the iPerf service
AnywhereUSB® Plus User Guide 301
n
To limit access based on firewall zones:
a. Click Zones .
b. For Add Zone , click g .
c. For Zone , select the appropriate firewall zone from the dropdown.
See Firewall configuration for information about firewall zones.
d. Click
g
again to allow access through additional firewall zones.
7. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the iPerf server:
(config)> service iperf enable true
(config)>
4. (Optional) Set the port number for the iPerf server listening port. The default is 5201.
(config)> service iperf port port_number
(config)>
5. (Optional) Set the access control list to restrict access to the iPerf server:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service iperf acl address end value
(config)>
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any : No limit to IPv4 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service iperf acl address6 end value
(config)>