Digi AnywhereUSB Plus, User Manual, Page: 524 / 815

Routing IP routing
AnywhereUSB® Plus User Guide 524
n
address : Matches the destination IPv4 address to the specified IP address or network.
Set the address that will be matched:
(config network route policy 0)> dst address value
(config network route policy 0)>
where value uses the format IPv4_address [ / netmask ] , or any to match any IPv4
address.
n
address6 : Matches the destination IPv6 address to the specified IP address or network.
Set the address that will be matched:
(config network route policy 0)> dst address6 value
(config network route policy 0)>
where value uses the format IPv6_address [ / prefix_length ] , or any to match any IPv6
address.
n
mac : Matches the destination MAC address to the specified MAC address. Set the MAC
address to be matched:
(config network route policy 0)> dst mac MAC_address
(config network route policy 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.