Digi AnywhereUSB Plus, User Manual, Page: 476 / 815

Diagnostics Configure options for the event and system logs
AnywhereUSB® Plus User Guide 476
n
To disable status event messages:
(config system log remote 0)> status false
(config system log remote 0)>
n
To disable informational event messages:
(config system log remote 0)> error false
(config system log remote 0)>
4. Set the port number to use for the syslog server:
(config system log remote 0)> port value
(config system log remote 0)>
where value is any integer between 1 and 65535 . The default is 514 .
5. Set the IP protocol to use for communication with the syslog server:
(config system log remote 0)> protocol value
(config system log remote 0)>
where value is either tcp or udp . The default is udp .
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure options for the event and system logs
The default configuration for event and system logging is:
n
The heartbeat interval, which determines the amount of time to wait before sending a
heartbeat event if no other events have been sent, is set to 30 minutes.
n
All event categories are enabled.
To change or disable the heartbeat interval, or to disable event categories, and to perform other log
configuration:
É
WebUI