Digi AnywhereUSB Plus, User Manual, Page: 551 / 815

Routing Virtual Router Redundancy Protocol (VRRP)
AnywhereUSB® Plus User Guide 551
5. Click Enable .
6. For Interface , select Interface: ETH2 .
7. For Router ID , leave at the default setting of 50 .
8. For Priority , type 80 .
9. Click to expand Virtual IP addresses .
10. Click g to add a virtual IP address.
11. For Virtual IP , type 192.168.3.3 .
Task 2: Configure VRRP+ on device two
1. Click to expand VRRP+ .
2. Click Enable .
3. Click to expand Monitor interfaces .
4. Click
g
to add an interface for monitoring.
5. Select Interface: Modem .
6. Click to enable Monitor VRRP+ master .
7. For Priority modifier , type 30 .
Task 3: Configure the IP address for the VRRP interface, ETH2, on device two
1. Click Network > Interfaces > ETH2 > IPv4
2. For Address , type 192.168.3.2/24 .
3. For Default gateway , type the IP address of the VRRP interface on the master device,
configured above in Task 3, step 2 ( 192.168.3.1 ).