Virtual Private Networks (VPN)
OpenVPN
AnywhereUSB® Plus User Guide
626
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> add vpn openvpn client
name
(config vpn openvpn client
name
)>
where
name
is the name of the OpenVPN server.
The OpenVPN client is enabled by default. To disable the client, type:
(config vpn openvpn client
name
)> enable false
(config vpn openvpn client
name
)>
4. The default behavior is to use an OVPN file for client configuration. To disable this behavior
and configure the client manually:
(config vpn openvpn client
name
)> use_file false
(config vpn openvpn client
name
)>
5. Set the mode used by the OpenVPN server:
(config vpn openvpn client
name
)> device_type
value
(config vpn openvpn client
name
)>
where
value
is either
tun
or
tap
. The default is
tun
.
6. Set the firewall zone for the OpenVPN client:
(config vpn openvpn client
name
)> zone
value
(config vpn openvpn client
name
)>
To view a list of available zones:
(config vpn openvpn client
name
)> zone ?
Zone: The zone for the openvpn client interface.
Format:
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Current value:
Summary of Contents for AnywhereUSB Plus
