Digi AnywhereUSB Plus, User Manual, Page: 490 / 815

Diagnostics Analyze network traffic
AnywhereUSB® Plus User Guide 490
b. Set the mode that will be used to run the capture filter:
(config network analyzer name )> when mode
(config network analyzer name )>
where mode is one of the following:
n
boot : The script will run once each time the device boots.
n
interval : The script will start running at the specified interval, within 30 seconds
after the configuration change is saved. If interval is selected, set the interval:
(config add network analyzer name )> on_interval value
(config add network analyzer name )>
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number { w|d|h|m|s }.
For example, to set on_interval to ten minutes, enter either 10m or 600s :
(config network analyzer name)> on_interval 600s
(config network analyzer name)>
n
set_time : Runs the script at a specified time of the day. If set_time is set, set the
time that the script should run, using the format HH : MM :
(config network analyzer name )> run_time HH : MM
(config network analyzer name )>
n
maintenance_time : The script will run during the system maintenance time
window.
c. Set the amount of time that the scheduled analyzer session will run:
(config network analyzer name )> duration value
(config network analyzer name )>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number { w|d|h|m|s }.
For example, to set duration to ten minutes, enter either 10m or 600s :
(config network analyzer name)> save_interval 600s
(config network analyzer name)>
d. Set the frequency with which captured events will be saved:
(config network analyzer name )> save_interval value
(config network analyzer name )>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number { w|d|h|m|s }.
For example, to set save_interval to ten minutes, enter either 10m or 600s :