Detroit Diesel 4000 Series, Service Manual, Page: 743 / 2706

SERIES 4000 12/16V SERVICE MANUAL
C 053.05.12 – AFTER-INSTALLATION OPERATIONS
Listed in Table 47are the After-Installation Operations for the camshaft thrust bearing.
Level of Maintenance Operation Reference
1, 2, 3 Install pushrods Refer to section C 055.05.11
1, 2, 3 Install valve gear Refer to section C 055.05.11
1, 2, 3 Install valve covers Refer to section C 056.05.11
1, 2, 3
Install oil heat exchanger with coolant distribution
housing and thermostat
Refer to section C 185.05.11
1, 2, 3 Install turbocharger Refer to section C 101.05.11
1, 2, 3 Install oil supply line for turbochargers Refer to section C 187.05.11
1, 2, 3 Install oil return lines for turbochargers Refer to section C 188.05.11
1, 2, 3 Install coolant lines Refer to section C 203.05.11
1, 2, 3 Install charge air coolant vent lines Refer to section C 205.05.11
1, 2, 3 Install engine coolant vent lines Refer to section C 205.05.11
1, 2, 3 Install charge air coolant lines (low temperature) Refer to section C 207.05.11
1, 2, 3
Install intake air system from turbocharger
to intercooler
Refer to sectionC 125.05.11
1, 2, 3 Install Y-pipe at exhaust outlet housing Refer to section C 141.05.11
1, 2, 3 Install vibration damper (if removed) Refer to section C 035.05.11
1, 2, 3 Install engine carrier (gear case) Refer to section C 231.05.11
1, 2, 3 Install fan drive Refer to section C 221.05.11
1, 2, 3 Fill charge air coolant system Refer to section C 206.05.11
1, 2, 3 Fill engine coolant system Refer to Operators Guide
1, 2, 3 Enable engine start Refer to Operators Guide
1 = The engine is to be completely disassembled.
2 = The engine is to be removed but not completely disassembled.
3 = The engine is to remain installed.
Table 47 After-Installation Operations
All information subject to change without notice.
Copyright © DETROIT DIESEL CORPORATION
C -597