Detroit Diesel 4000 Series, Service Manual, Page: 354 / 2706

SERIES 4000 12/16V SERVICE MANUAL
14. Degrease and dry mating surface (2). See Figure 151.
1. O-ring Bore 3. Cotton Seal
2. Mating Surface
Figure 151 Coating Mating Surfaces on Block for Gear Case
15. Coat mating block surface with Gasket Eliminator 518 and attach cotton seal (3). Fit
closely to O-ring bore (1).
16. Coat O-rings (1) with petroleum jelly, and insert in groove on gear case. See Figure 151.
17. Using crane, carefully move gear case over crankshaft guide bushing. Refer to section C
024.05.01.
18. Ensure that studs are properly aligned.
NOTE:
Ensure components are reinstalled in accordance with markings, and note that bolts
differ in length.
19. Install all securing bolts and tighten uniformly.
20. Install nuts and washers and tighten.
21. Torque securing bolts and nuts to specification. Refer to section A 003.
NOTE:
Ensure that final strength of surface sealant is correct.
All information subject to change without notice.
C -208
Copyright © DETROIT DIESEL CORPORATION