Detroit Diesel 4000 Series, Service Manual, Page: 1156 / 2706

SERIES 4000 12/16V SERVICE MANUAL
6. Slide air intake manifold with O-ring into previously installed adjacent air intake manifold
(1), and position it on sealing surface of cylinder head.
NOTE:
Before tightening hex bolts, check that gasket is correctly positioned.
7. Install O-ring (5) over charge air cover outlet elbow (4) and coat with petroleum jelly.
See Figure 706.
1. Outlet Flange Outlet Charge Air Cooler 4. Outlet Elbow
2. Hex Bolt 5. O-ring
3. Hex Nut
Figure 706 Installing Outlet Elbow in Charge Air Cooler Outlet Flange
8. Coat O-ring (5) with petroleum jelly and insert in outlet elbow flange to charge air cooler
(1).
9. Install outlet elbow in charge air intake manifold so that outlet elbow flange is flush with
outlet flange on charge air cooler.
10. Install and tighten hex bolts (2) and hex nuts (3) securing elbow and charge air cooler.
Torque bolts to specification. Refer to section A 003.
All information subject to change without notice.
C -1010
Copyright © DETROIT DIESEL CORPORATION