Detroit Diesel 4000 Series, Service Manual, Page: 285 / 2706

SERIES 4000 12/16V SERVICE MANUAL
C 015.05.11 – INSTALLATION OF ENGINE LIFTING ATTACHMENTS
Perform the following steps to install engine lifting attachment.
1. Place lifting attachments (2) on cylinder head edges and align to the bores for the cylinder
head bolts. See Figure 103.
1. Cylinder Head 3. Mounting Bolt
2. Lifting Attachments 4. Washer
Figure 103 Placing Lifting Attachments on Cylinder Head Edges
2. Screw in cylinder head bolt with thrust washer and tighten studs to specification.
Refer to sectionA 003.
NOTE:
If, at both of the cylinder heads that carry the lifting attachments, only the cylinder
head bolts at the lifting attachments itself were released, then it is sufficient to tighten
both of these cylinder head bolts to torque/additional angle of rotation to specification.
Refer to section A 003. Refer to section C 041.05.01. If, at both of the cylinder heads
that carry the lifting attachments further cylinder head bolts were released, then the
“cylinder head tightening diagram” applies entirely; refer to section A 003. For installation
of cylinder head, refer to section C 041.05.11.
All information subject to change without notice.
Copyright © DETROIT DIESEL CORPORATION
C -139