Detroit Diesel 4000 Series, Service Manual, Page: 450 / 2706

SERIES 4000 12/16V SERVICE MANUAL
27. If remaining elongation of studs is outside tolerance, release nuts. Refer to section C
031.05.05 and repeat nut tightening procedure; if necessary, replace studs.
28. Tighten side hex socket bolts (1) to specifications in same sequence as when tightening
bearing caps. Torque to specification. Refer to section A 003. See Figure 230.
1. Main Bearing Cap Stabilizer Bolt 3. Main Bearing Cap Nut
2. Ratchet and Socket Wrench
Figure 230 Tightening Main Bearing Cap Stabilizer Bolts
Measuring Main Bearing I.D.
Perform the following steps to measure main bearing I.D.
All information subject to change without notice.
C -304
Copyright © DETROIT DIESEL CORPORATION