Detroit Diesel 4000 Series, Service Manual, Page: 475 / 2706

SERIES 4000 12/16V SERVICE MANUAL
11. Install the threaded shaft into adapter hub.
To avoid injury from failure of a fitting, hose, or oil cooler
core, wear a face shield or goggles when conducting a
pressure test.
12. Install the high-pressure line of the hand pump (1). See Figure 248.
NOTE:
Ensure that the flywheel guide studs are removed.
1. High-Pressure Line of Hand Pump 3. Rear Crankshaft Hub
2. TRS Wheel
Figure 248 Crankshaft Hub Installer Sleeve
13. Lubricate the threaded shaft, nut and washers with Anti-Seize.
14. Install the washers and nut onto the shaft. Fully tighten, then back off a distance equal to
that of the push-on dimension.
15. Install the high-pressure line into the drive flange.
NOTE:
Do not tighten at this time.
All information subject to change without notice.
Copyright © DETROIT DIESEL CORPORATION
C -329