Danfoss MCO 305, Design Manual, Page: 217 / 242

MCO 305 Design Guide
__ Parameter Reference __
¾ default setting [ ] value for use in communication via serial communication port
MG.33.L4.02 – VLT
®
is a registered Danfoss trademark
217
†
MCO Advanced Settings, Parameter List
Par. No.
# Parameter name Parameter description Default
setting
Changes
during
operation
4-set-up Conver-
sion
index
Type
33-0* Home Motion
33-00 HOME_FORCE Force HOME [0] not forced 'TRUE' 1 set-up Uint8
33-01 HOME_OFFSET Zero Point Offset from
Home Position 0 qc TRUE 1 set-up Int32
33-02 HOME_RAMP Ramp for Home Motion 10 TRUE 1 set-up Uint16
33-03 HOME_VEL Velocity of Home Motion 10 TRUE 1 set-up Int16
33-04 HOME_TYPE Behavior during Home
Motion [0] R
Index
TRUE 1 set-up Uint8
33-1* Synchronization
33-10 SYNCFACTM Synchronization Factor
Master (M:S) 1 TRUE 1 set-up Int32
33-11 SYNCFACTS Synchronization Factor
Slave (M:S) 1 TRUE 1 set-up Int32
33-12 SYNCPOSOFFS Position Offset for
Synchronization 0 qc TRUE 1 set-up Int32
33-13 SYNC ACCURACY Accuracy Window for
Position Synchronization 1000 qc TRUE 1 set-up Int32
33-14 SYNCVELREL Relative Slave Velocity
Limit 0 % TRUE 1 set-up Uint8
33-15 SYNCMARKM Marker Number for Master 1 TRUE 1 set-up Uint16
33-16 SYNCMARKS Marker Number for Slave 1 TRUE 1 set-up Uint16
33-17 SYNCMPULSM Master Marker Distance 4096 TRUE 1 set-up Uint32
33-18 SYNCMPULSS Slave Marker Distance 4096 TRUE 1 set-up Uint32
33-19 SYNCMTYPM Master Marker Type [0] Enc. Z pos. TRUE 1 set-up Uint8
33-20 SYNCMTYPS Slave Marker Type [0] Enc. Z pos. TRUE 1 set-up Uint8
33-21 SYNCMWINM Master Marker Tolerance
Window 0 TRUE 1 set-up Uint32
33-22 SYNCMWINS Slave Marker Tolerance
Window 0 TRUE 1 set-up Uint32
33-23 SYNCMSTART Start Behavior for
Synchronization [0] Start Funct.
1
TRUE 1 set-up Uint16
33-24 SYNCFAULT Marker Number for Fault 10 TRUE 1 set-up Uint16
33-25 SYNCREADY Marker Number for Ready 1 TRUE 1 set-up Uint16
33-26 SYNCVFTIME Velocity Filter 0 P s TRUE 1 set-up 0 Int32
33-27 SYNCOFFTIME Offset Filter Time 0 ms TRUE 1 set-up Uint32
33-28 SYNCMFPAR Marker Filter Configuration [0] Marker
Filter 1
TRUE 1 set-up Uint8
33-29 SYNCMFTIME Filter Time for Marker
Correction 0 ms TRUE 1 set-up Int32
33-30 SYNCM MAXCORR Maximum Marker
Correction
[0] Off TRUE 1 set-up Uint32
33-31 SYNCTYPE Synchronization Type [0] Standard TRUE 1 set-up Uint8