
MCO 305 Design Guide
__ Parameter Reference __
¾
default setting
[ ]
value for use in communication via serial communication port
182
MG.33.L4.02 – VLT
®
is a registered Danfoss trademark
MCO Parameters
For a better overview the MCO Parameters are divided into groups:
32-**
MCO Basic Settings
32-0*
Encoder 2 - Slave
page 183
32-3*
Encoder 1 - Master
page 184
32-5*
Feedback Source
page 188
32-6*
PID controller
page 189
32-8*
Velocity & Acceleration
page 191
33-**
MCO Advanced Settings
33-0*
Home
Motion
page
193
33-1*
Synchronization
page 194
33-4*
Limit
Handling
page
204
33-5*
I/O Configuration
page 205
34-**
MCO Data Readouts
page 211
34-0*
PCD
Write
Parameters
page
211
34-2*
PCD Read Parameters
page 211
34-4*
Inputs & Outputs
page 212
34-5*
Process Data
page 212
General Information on the Parameter Values
Some limiting values are listed at 1 billion to make them more easily readable. However, the exact value is
1,073,741,823. (= MLONG).
Input Range
Whether the input range listed is exceeded is not checked by the program, since due to the large domain
there are no suitable test possibilities.
NB!:
Even within the areas indicated illogical inputs can result from the large differences in performance
of the motors and the wide variety of possible applications. Therefore, it is the responsibility of the
programmer and the user to observe the performance ranges of the drive and of the system.
NB!:
If the value of the parameter is out of the range defined by the minimum and maximum value the
command is not displayed and executed correct.
Summary of Contents for MCO 305
Page 4: ......