Danfoss MCO 305, Design Manual, Page: 147 / 242

MCO 305 Design Guide
__ Software Reference __
MG.33.L4.02 – VLT
®
is a registered Danfoss trademark
147
†
SAVEPROM
Summary saves memory in EEPROM
Syntax SAVEPROM
Description When changing array elements or application parameters (group 19-**) while the
program is running SAVEPROM offer the possibility of saving the values which have
been changed. This must be done by triggering the command SAVEPROM explicitly.
SAVEPROM triggers the same process, which can also be started in the menu
Controller .
If you want to save only array elements or only global and application parameters,
use the corresponding commands SAVE .. ARRAY, GLBPAR, or USRPARS.
NB!:
The execution time of SAVEPROM depends on the amount of data to be saved. It
can be up to 4 seconds.
NB!:
Please note that the MCO parameters (group 32-** and 33-**) are not saved by
SAVEPROM. To do this you must use the command SAVE AXPARS.
NB!:
The EEPROM can only handle execution of this command up to 10000 times.
Command Group INI
Syntax Example PRINT "please wait"
SAVEPROM
PRINT "Thanks"
†
SET
Summary sets a parameter
Syntax SET par v
Parameter par = Parameter identification
v =
parameter value
Description With the SET command parameters can be temporarily changed while the program
is running.
The parameter codes permitted can be found in the Parameter Reference .
NB!:
The parameter alterations are only valid while the program is running. After pro-
gram end or abort, the original parameter values are valid again.
The parameter alterations can be made permanent by using the command
SAVEPROM.
Command Group PAR
Portability SET I_xxx commands will still work and automatically be transferred into the new
I_FUNCTION parameters.
Cross Index GET, Parameter Reference
Syntax Examples SET POSLIMIT 100000 /* set positive positioning limit */
SET KPROP 150 /* change proportional factor */
SET PRGPAR 2 /* change activated program number */
SET I_FUNCTION_9_n /* previously the command SET I_BREAK */