Danfoss MCO 305, Design Manual, Page: 112 / 242

MCO 305 Design Guide
__ Software Reference __
112
MG.33.L4.02 – VLT
®
is a registered Danfoss trademark
†
ERRNO
Summary System variable with the actual error code
Syntax res = ERRNO
Description ERRNO is a system variable which is available in all the programs, and contains the
momentary error code. All error codes are explained in the chapter
Troubleshooting.
If, at the time of inquiry no error has occurred, then ERRNO will contain a 0.
Portability Standard variable
Command Group I/O
Cross Index ON ERROR GOSUB, ERRCLR,
Warnings and Error Messages
Syntax Example PRINT ERRNO /* display actual error code */
Program Sample ERROR_01.M, IF_01.M, INDEX_01.M
†
EXIT
Summary Premature program termination
Syntax EXIT
Description The EXIT command ends a program where active positioning procedures are being
carried out to the end.
The EXIT command is especially intended for use in an error treatment routine, and
permits an unplanned program termination in the case of an un-correctable error
occurrence.
After an abort with EXIT, programs marked with Autostart will start up again
automatically if
SET PRGPAR = -1.
NB!:
A program should only be terminated in the case of a serious error, e.g. when
reacting to a limit switch.
Command Group CON
Cross Index ON ERROR GOSUB, SET,
Parameter: 33-80 Activated Program Number PRGPAR, Autostart
Syntax Example EXIT /* Program termination */
Program Sample EXIT_01.M, ERROR_01.M