CyberOptics SE505, Hardware Manual

Page: 66 / 180

Chapter 3 : Installation
56 SE505 Hardware Manual
➢
To assign access to groups
1. On the
Security
menu, click
Secure Assignments
.
2. In the Secure Assignments window, select a Group from the list. You should have the
following four groups from which to choose: Supervisors, Engineers, Lead Operators, and
Operators.
3. To add access to a Secure Area, select the name from the
Unassigned
list and click
Add
.
4. To change access to a Secure Area, select the name from the
Assigned
list and click
Remove
. Then add the Secure Area to a different group as described in steps 2 and 3 above.
5. Click on
OK
to save your changes or
Cancel
to close the window without making changes.
When you click OK, your changes are saved to a file named SE505.sec located in the default
security directory. The settings in the security file are loaded each time the application
starts.
System Calibration
Configuration Allows group members to modify system alignment
settings in the configuration editor. Solder Paste Inspection
System Settings Configuration Allows group members to modify system settings in the
configuration editor. Solder Paste Inspection
i
Notes:
●
You must be a member of the group assigned to the Security Setup Secure Area to make
changes to Security Assignments.
●
Assign Secure Areas from within the both Solder Paste Inspection and Teach applications.
●
All Secure Areas must be assigned to a group.
Table 9. Secure Areas (Continued)
Secure Area Description Application Where
Used