CyberOptics SE505, Hardware Manual

Page: 119 / 180

CyberOptics Corporation 109
Conveyor Components
Replacing the Autowidth Motor
Use this procedure to replace the autowidth motor. This procedure can be performed with access
to the left/right of the machine in production line. The illustrations in this section show the
procedure performed when the machine is not in the production line.
Parts
DC Brushless Motor
Required Tools
– No. 3 Allen key
– No. 2 Allen key
– No. 8 Spanner
➢
To replace the Autowidth Motor
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 59.
2. Open the hood.
3. Make sure all motion has stopped.
4. Loosen the four nuts by using spanner No. 8.
5. Remove the two screws by using Allen key No. 3.
i
Note:
For Parts Replacement, contact CyberOptics for part numbers.
Screws
Allen key No.3