CyberOptics SE505, Hardware Manual

Page: 162 / 180

Chapter 4 : Replacing Components and Preventive Maintenance
152 SE505 Hardware Manual
Sensor
Sensor Replacement
The SE505 sensor is maintenance-free. The life of the sensor is determined by the duration and
amount of use.
If you have problems with the sensor or you suspect that the sensor needs to be replaced, call
your CyberOptics Service and Support representative. (See “
Technical Support ” on page ix)
➢
To replace the sensor
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 59.
2. Open the SE505 hood.
3. Loosen the two screws from the Camera Link connector on the back of the sensor.
4. Disconnect the Camera Link cable from the connector on the back of the sensor.
5. Disconnect the Illumination Control Cable from the connector on the side of the sensor.
6. Remove the three captive M6 x 45 screws using a 5 mm allen wrench.
7. Remove the sensor from the mounting plate.
8. Replace with a new sensor.
For more information on installation of the sensor, refer to the section “ Installing the Sensor ” on
page 39.
Warning: Do not open the sensor case. Opening the sensor case may cause electrical shock and
will void the CyberOptics warranty.