CyberOptics SE505, Hardware Manual

Page: 62 / 180

Chapter 3 : Installation
52 SE505 Hardware Manual
Setting Up System Security
The SE505 software contains a security feature used to control access to certain features. SE505
security applies a system of Groups and Users to determine which logon names can access a
given function. The default security setup includes the following groups:
●
Supervisors
●
Engineers
●
Lead Operators
●
Operators
The default security system includes the following user logons:
●
Supervisor
●
Engineer
●
Lead Operator
●
Operator
Anyone using the SE505 can use one of the default logons (password CyberOptics ). The default
setup allows full access to all SE505 features for all users except for the Security Setup feature.
Only the Supervisor logon has rights to change the Security Setup by default.
The default setup also includes an Auto logon feature, so that when any of the default system
logons are used, a separate SE505 logon is not required.
If you are logged on as a Supervisor (or user with Supervisor rights) you can change the
security setup at any point to allow access to certain features depending on the system logon.
For more information about assigning access, refer to pages “
Assigning Secure Areas ” on page 55
and “ To assign access to groups ” on page 56.
i
Note: The order of the groups listed above is from the most to least privileged and always
include all lower level privileges.
i
Note: If the security feature is not a requirement in your facility, use the default logons for the
least amount of setup.