CyberOptics SE505, Hardware Manual

Page: 13 / 180

CyberOptics Corporation 3
Safety Guidelines
Emergency Stop
Stop all movement on the SE505 system by using the Emergency Stop (E-Stop) button. Motion
will also stop when a safety interlock is disengaged.
Using the Emergency Stop Button (E-Stop)
The E-Stop button is located on the front, right side of the SE505 system. When the E-Stop button
is pushed all motion in the system stops and power is removed from their circuitry.
The E-Stop on this machine is designed to meet the harmonised European standard for safety of
machinery— electrical equipment EN 60204-1 and EN 954-1 Category 4.
Figure 1. Emergency Stop Button
➢
To operate the E-Stop
1. Push the red E-Stop button to stop the conveyor and stage movement.
2. Twist and pull the E-Stop button to disengage, then press the yellow E-Stop Reset button to
restart the system.
When the E-Stop button is pressed, or an interlock is broken, the E-Stop button will light up,
giving an indication of the machine status. After clearing the E-Stop button or securing the
interlock, the light turns off.
Caution
: Always press the Emergency Stop button before clearing a conveyor malfunction,
before performing machine maintenance, or before reaching inside the machine for any reason.
E-Stop
E-Stop
Reset
i
Note: Air is still supplied to the conveyor panel lifter and the conveyor clamps after pressing the
E-Stop button but they will return to lift down or clamps up when E-Stop button is activated.