CyberOptics SE505, Hardware Manual

Page: 61 / 180

CyberOptics Corporation 51
Configuring the Pressure Gauge Display
5. Set the high trigger set point by pressing and to cycle through the values.
6. Stop on the value and wait 5 seconds to end programming mode.
➢
To set the operating mode
The operating mode should be set to Window Comparator Mode by default. If not, change the
mode as follows:
1. Press one time until option 1 appears.
2. Wait three seconds to enter mode 1.
3. With
ou1
displayed, press to choose
Cnp.
(
ou1
= output 1,
Cnp
= Window Comparator Mode)
4. Press to select End .
➢
To change the display color
1. Press six times until option 6 appears.
2. Wait three seconds to enter mode 6.
3. Press to cycle through the color options:
2-r:
On=Red, Off=Green
2-9
: On=Green, Off=Red
1-r
: On=Red, Off=Red
1-9 : On=Green, Off=Green
off
: Turn off display
4. Press to select End .
➢
To lock/unlock the display controls
1. Press and hold .
2. Press to lock ( Loc ).
3. When locked, press and hold .
4. Press to unlock ( UnC ).
i
Note : if H-1 or h-1 appears instead, change the operating output mode as described in “ To set the
operating mode ” below.